By Capt. Joe Shute
Most ballyhoo rigs use a stiff wire pin for the anchoring and pulling point for the ballyhoo’s head. Pinless ballyhoo rigs take a different approach. For this method of rigging you need to use either a ballyhoo spring, copper wire or a rubber band to secure the head of the ballyhoo to the pin. The pinless rig will not use the stiff wire pin as a pulling point. The ballyhoo’s head will actually be hard-wired to the leader using the ballyhoo’s whole head as the pulling point.
First, prepare the ballyhoo for rigging. Thaw the ballyhoo, and when it is completely thawed out you can prepare it. Take the ballyhoo belly up and “milk” the belly section. This is also called “pooping the ballyhoo.” Take your thumb and forefinger and squeeze the ballyhoo’s stomach, starting just behind the gills and working back to the anal vent. This cleans out all the internal mass and fluids that are in the belly cavity, which will help limber up the ballyhoo and also help with the hook placement. Repeat this “milking” a few times until you feel most of the internal fluids have exited the anal vent.

Next I take a pair of scissors and clip off the pectoral fins on the ballyhoo. These are the fins on either side of the body and just behind the gill plates of the ballyhoo. The reason for clipping these fins off is sometimes when the ballyhoo are packaged, these fins will not be lying flat. That







![furuno safety 468x60[61]](https://biggamefishingjournal.com/wp-content/uploads/Furuno-Safety-468x6061-2.gif)




